BORATE FUSION FLUXER
The Katanax Fluxer K1 Prime from SPEX – preparation of glass disks (beads) for XRF or solutions for AA and ICP with one sample position, fully electric without gas or other media ... Fusion has never been so easier and safer.
The K1 Prime has an intuitive touchscreen operation and works fully automatically, which ensures fast, simple and, above all, reproducible sample preparation with maximum efficiency. The change from preparing glass disks to solution preparation takes place in a few simple steps by replacing the crucible heater module with the (optional) stirring module without needing tools.
The Katanax Fluxer X-300 from SPEX - preparation of glass disks (beads) for XRF or solutions for ICP with one, two or three sample positions, fully electric without gas or other media ... Fusion has never been so easier and safer.
The modular X-300 from Katanax has an intuitive touchscreen operation and works fully automatically. Seven independently controlled heating elements made of acid-resistant ceramic guarantee exact temperature control and thus reproducible results with a long service life. The optionally available stirring module can remain installed permanently and enables a quick change from preparing glass disks to solution preparation.
The Katanax X-Fluxer® X-600 from SPEX – preparation of up to 6 glass disks for XRF or up to 6 solutions for ICP in parallel - fully electrically without gas or other media ... Fusion has never been so easier and safer
The X-600 from Katanax has an intuitive touchscreen operation and works fully automatically. Seven independently controlled heating elements made of acid-resistant ceramic guarantee exact temperature control and thus reproducible results with a long service life. The optionally available stirring module can remain installed and enables a quick change from preparing glass disks to solution preparation.
The automatic dosing machine SPEX Sampleprep Katanax XFP-01 FluxPenser® - precise and reproducible weighing of flux - including balance and LIMS compatibility
There are two operating modes to choose from for dispensing fusion flux, either dispensing a defined amount (for ICP) or dispensing a certain flux / sample ratio (for XRF). The correct amount of flux is calculated automatically, the accuracy of dispensing is within 1 mg.